I can email or post the details for wither method if needed.Ĭollecting & processing Raw data with Leica GS 14 Look at the options and let me know what you think. If you are only collecting points in XYZ with no codes you can collect points as fast as 0.05 Hz. If you want to store codes with your autopoints you need to know that the system can only store points with codes if it is storing points at 1 Hz or slower. One thing you need to know related to storing codes. You can choose to have to manually start and stop recording or just automatically recordħ. There are some QC options that monitor the quality of the position before storingĦ. You have options to record by distance or time and a few others. Then you will be able to configure the options and then you will have the AUTO page in the main view of the Survey application where you can start and stop the AutoPoints.ĥ. Page over to AutoPoint section and select “Log auto points”. Once in the survey application choose the green function key (Fn) and then F2 (CONFIG)Ĥ. If you are using RTK you need to use the AutoPoints feature…ģ. You can do these settings in both the CS controller or by using the web interface built into the receiver. You will need to manually input you antennae height in the data.
#PROCESS STATIC GPS DATA WITH LEICA GEO OFFICE SERIAL NUMBER#
The name of the raw data file (.moo) will have the (by default) the last 4 digits of the serial number of the receiver with the data and time to make up the file name. To stop the logging and close the session file just turn off the receiver. Start logging static when GS is turned on – settings are made so that once the GS14 is turned on and gains an autonomous position the unit will automatically start to log raw data. Raw data (.m00) file will have the job name included in the name to the fileĢ. Start the static session with your controller and then disconnecting – GS14 will continue to log raw data but with have the antenna height and starting point name you entered using the CS controller. OK… so there are two options when storing to the MicroSD in the GS14…ġ. Especially in your case with just mounting the receiver to a mag mount and then collecting data I would choose the option to store directly to the MicroSD card in the GS14. With the collection of RAW static/ kinematic data you can collect data for post process kinematic by logging raw data to the MicroSD in the GS14 or to the controller. You can do this by either collecting raw data to post process later or you can try to do RTK and use the autopooint feature.
0 kommentar(er)
